4HP-8HP Header Kit

£1.70 (Excl. VAT)

Headers to connect an N8 Eurorack Control Deck to an N8 Solderable Breadboard for Eurorack.

This kit is suitable for our 4HP 1×6, 6HP 2×6 and 8HP 2×5 Control decks

  • 1x 40 Pin 2.54mm Single Row Female Pin Header
  • 1x 40 Pin 2.54mm Right Angle Single Row Male Pin Header
  • 1x 16 Pin 2.54mm Double Row Male Pin Header – for Eurorack power connection

51 in stock

Mounting the 8HP 2x5 Eurorack Control Deck

N8 Eurorack Breadboards are connected to N8 Eurorack Control Decks using standard 2.54mm pin headers.

A 40-pin 2.54mm single-row female pin header is soldered to the rear of the Control Deck. We recommend this is done before you mount components on the front of the Control Deck. 

A 40-pin 2.54mm single row right angle male pin header is soldered to the breadboard. For an 8HP 2×5 module,  the pin header is mounted on the rear/solder side of the breadboard. This will ensure proper clearance when the module is mounted in your case. We recommend attaching the pin header to the breadboard after all other components have been placed and soldered.

The two pin-headers attach the control deck to the breadboard and provide connectivity for the components mounted on the control deck.

Hex nuts, supplied with our pots and 3.5mm jack sockets, attach our pre-drilled 8HP 2×5 Eurorack panel to the jacks and pots on the control deck, completing your DIY synth module. 

A diagram showing a the N8 Synth 8HP 2x5 Eurorack Control Deck connections